Campomatic RB2200 - Manual (Page 9)

8
ASSEMBLY
ACCESSORIES
USE
• Connect the flexible vacuum hose (5) with the vacuum connection (18) of the appliance: Insert the tube
coupling (6) into the tube connection (18), lock into place by turning the coupling as far as it will go in a
clockwise direction.
• Now connect the hand grip (1) of the vacuum hose to the vacuum tube (4). The desired length of the
adjustable telescoping tube (4A) can be set by pressing the adjusting button (4B) in the direction
indicated by the arrow and pulling the telescoping tube out or pushing it in [fig. B1].
• Now select the combination brush (8) or the suitable accessory (10) for the surface to be cleaned and
attach it to the vacuum tube (4).
Combination brush for carpet / bare floor (8):
Set the combination brush to the floor type with the selector switch (9) [fig. C1]:
- Selector switch (9) setting A (brush extended): for bare floors
- Selector switch (9) setting B (brush retracted): for rugs and carpet
Your appliance is equipped with the following accessories:
Note: The accessories can be connected to the vacuum tube (4) or directly to the hand grip (1).
Your appliance is equipped with an antiallergic HEPA filter for especially clean exhaust air and is therefore
appropriate for allergy sufferers.
When not using the accessory (10), you can store it in the accessory compartment (3) [fig. C2, C3].
Pull out the power cord (22) completely, but no farther than the red marking, and insert the plug into the
power socket. The yellow cord marking is located before the end of the cord with the red marking.
Press the ON/OFF switch (19) once to switch the appliance on or off.
The suction power can be changed with the manual airflow regulator (2) on the hand grip (1) [fig. D1].
Closed:
Increases the suction power
Open: Reduces the suction power
After finishing your work, switch off the appliance by pressing the ON/OFF switch (19) and pull the power
plug out of the socket.
Open the airflow regulator (2) to reduce the suction power if an object was sucked up and is blocking the
opening.
Press the button for the automatic cord winding (21) to wind up the power cord. Hold the plug firmly during
the automatic winding to prevent it from whipping around.
The vacuum hose (5) can be disconnected from the appliance for storage. Turn the tube coupling (6) in an
anticlockwise direction as far as it will go and pull out the tube.
The combination brush (8) can be hung on the appliance for storage, the corresponding figure in the image
section is marked with the parking symbol
[fig. D2].
GB
Crevice nozzle (10A): Cleaning of corners and crevices, e.g. for radiators, moulding, roller shutters,
awnings;
Cushion brush (10B): Cleaning of sofas, armchairs, upholstered chairs and curtains;
Dust nozzle (10C): Cleaning of small objects, audio and video equipment, computers and furniture;
Parquet brush (10D): Special brush for cleaning of parquet floors.