Campomatic RS600 - Manual (Page 9)

Cleaning carpet
1. Remove lightweight furniture (table, lamps, etc.) from area to
be cleaned. Protect any remaining furniture by pinning up
furniture skirts and placing aluminum foil or plastic under legs.
B
A
16
2. Vacuum carpet thoroughly to remove loose dirty, hair, lint and
other debris.
3. Test detergent for colorfastness on a hidden area of carpet.
Wet a while cloth or paper tower with some detergent. Gently
rub onto a hidden area of carpet. Wait ten minutes. Blot with
white cloth or paper towel and check for color transfer.
4. Retreat spots stains and high traffic areas with Spray offered.
Spray spot or area with the spray. Then proceed with the next
cleaning steps.
5. Fill solution tank with hot tap water proper amount of
detergent.
6. Put the Hand-held (A) in the extractor body. Make sure
it is in the right position and turn the revolving bar to the
right side (B). (Fig16) Step on handle release pedal.
Turn extractor ON.
7. Pull the trigger up with the inclined direction to release
cleaning solution (Fig17). Push extractor forward slowly
then pull it back slowly.
8. Let go of trigger (C)(Fig.17) and push extractor over same area to
pick up dirty solution without putting down more solution.
Continue using dry strokes until you see only a little solution
coming up through the nozzle (front of extractor) or recovery
tank.
17
C
9. Do not make the carpet too wet! Use no more than two sets
of forward and backward strokes while releasing solution.
Always follow with dry strokes-the more the better.
10. Listen carefully! When the motor sound changes (rising in pitch),
the recovery tank needs to be emptied. When water has reached
the maximum capacity in the recovery tank, the float will rise
to the top of the tank and the extractor will not pick up dirty solution.
11. Allow carpet to dry. Avoid walking on the carpet until it is dry.
Increased air circulation (open doors, turn on fans, etc.) will help
carpet dry thoroughly to prevent the growth of mold or mildew.
12. Vacuum thoroughly after carpet has dries. This will reduce any
shading left by the extractor’s brushes.
8