Caple RiR121 - Manual (Page 5)

Preparation
Unpacking
Remove all packing materials.
Check attachments and materials
Checking should be conducted with reference to the Packing List. Contact the local
distributor if discrepancies are found.
Ensure proper location of the refrigerator.
Clean the refrigerator before use.
(See the following section “Cleaning”)
Idle time
After the refrigerator has been sited and cleaned, let it stand for more than 30 minutes
before connecting the power source.
Left/Right Door Opening（ （ （ （ （Figure A） ） ） ） ）
The door of the refrigerator can be opened both from the left or right as required. The
following are the steps required to position the door to open to the right.
1. Remove the lower bracket (1) on the right, the door and the screw hole cover (4).
2. Remove the lower bracket pivot (3) and the spring washer(2), and then place and fix
them in the hole on the left of the lower bracket.
3. Remove the cover (5) on the upper brackets on both left and right sides; remove the
bracket pivot on the right side and the spring washer and then fix them in the bracket
hole.
4. Fix the door between the upper and lower brackets on the left and fasten the lower
bracket by tightening the screws.
5. Fix the screw hole cover in the lower bracket hole on the right, and then fix the upper
bracket covers to the upper brackets on the left and right.
6. After installation open and close the door to ensure the door operates smoothly.
7. Move the components (7) and (8) with the special tool provided.
8. Remove the screw (9) from the refrigerator, open the door fully and replace screw (9) in
the corresponding opposite position.
4