Caple WF332 - Manual (Page 5)

4
① Rubber cover ② Screw ③ Decorative cover
④&⑦ Screw ⑤ Top hinge module ⑥ Door
⑧ Lower hinge module-Left ⑨ Cabinet’s leg-short
• Pull out the screw covers and unscrew the decorative cover. (Fig.1)
• While holding the door firmly, loosen and remove the top hinge, lift up and remove the door (See
Fig.2)
• Unscrew the lower hinge (8)
• Remove the long cabinet leg (9) on the left side, and shift it to the right end side. (Fig.3)
• Install the lower hinge and tie it with the bolts
• Install the door on the axe of lower hinge (8) the same way it was removed, screw back the top
hinge on the right
• Fix back the decorative cover and rubber cover.
Storage of wine
The water reservoir should be positioned in the centre of the top rack in each compartment if used.
To achieve maximum storage capacity, position the bottles alternately on the racks. (See below
diagram)
Installation of shelves
• To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment
• For easy access to the storage content, you must pull the shelves approximately 1/3 out of the
rail compartment, however this unit was designed with a notch on each sides of the shelf tracks
to prevent bottles from falling.