Caple TDi110 User Manual
Page 8
There is an automatic 12−minutes cool down period at the end of every cycle, during which
the heater is switched off. This is to help minimize creasing.
After each of the programmes, the machine goes into anti−crease. This feature rotates the
drum for briefly every 6 minutes until the dryer is stopped or the door is opened.
NOTE: NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM ˘
RISK OF FIRE.
When drying large items such as sheets, we suggest you periodically stop the dryer to
redistribute the load. To stop the machine during a programme, simply open the door, the
drum will stop rotating automatically and restart when you close the door. Press the start
button to restart the machine.
WARNING: Never stop a tumble dryer before the end of a drying cycle unless all items are
quickly removed and spread out so that heat is dissipated.
AFTER REMOVING THE DRIED CLOTHES: ALWAYS CLEAN THE FILTER.
Failure to clean the filter will extend drying times and cause the safety cut−out to operate.
Pull the filter upwards and away from the appliance.
Remove threads or fluff by hand or with a soft brush.
Slide the filter back.
Wash the filter occasionally in detergent solution and with a soft brush to remove small
particles.
TO AVOID MINOR FAULTS
If the clothes are not dry after normal drying time:
Check that you used the correct heater setting.
Check the fuse in the moulded plug.
Check that the lint filter has been cleaned. A blocked filter will restrict the airflow.
Check that your dryer is heating ˘ the right side below the door should feel warm after the
first 10 ˘ 15 minutes of its programme. Failure to heat may indicate the safety cut−out has
operated. To reset, simply press the red button at the rear of the machine. If operated, a
sharp click will be heard. This cut−out only operates if the air flow is severely restricted so
make sure the filter is clean, the air inlets and outlets at the front and back are not blocked,
and that all other restrictions are removed before re−starting. If the cut−out continues to
operate after checking the above points, you should contact your service agent.
Your dryer is designed to operate in a room temperature range of 5°C to
30
° C.