Caple C762GSS - Manual (Page 13)

29
FASTENING THE
INSTALLATION BRACKETS
(fig. 4.11)
✓ Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
✓ Turn the cooker top upside down and
fasten the brackets “A” to the appro-
priate socket holes, without tightening
the screws “B” for the moment.
✓ Make sure that the brackets are faste-
ned as shown in figure 4.11.
FASTENING THE COOKER TOP (fig. 4.12)
✓ Spread the sealing material “C” out along the fixture hole, making sure that the junc-
tions overlap at the corners.
✓ Insert the cooker top into the hole and position it correctly.
✓ Adjust the position of the brackets “A” and tighten screws “B” to block the cooker top
firmly in position.
✓ With a sharp cutter or trimmer knife trim the excess sealing material around the edge
of the cooker top.
20
mm min.
40
mm max.
B
D
F
F
F
R
R
C
B
D
R
C
Fig. 4.8
Fig. 4.9 Fig. 4.10
20
mm min.
40
mm max.
B
C
A
Fig. 4.12
FRONT
A
A
A
A
Fig. 4.11 A
A
FASTENING THE COOKER TOP (figs. 4.9 and 4.10)
✓ Spread the sealing material “C” out along the fixture hole, making sure that the junc-
tions overlap at the corners.
✓ Insert the cooker top into the hole and position it correctly.
✓ Adjust the position of the brackets “F and R” and tighten screws “B” to block the
cooker top firmly in position.
✓ With a sharp cutter or trimmer knife trim the excess sealing material around the edge
of the cooker top.
COOKING HOBS - P60 series
COOKING HOBS - P90 series
FASTENING THE
INSTALLATION BRACKETS
(figs. 4.8, 4.9, 4.10)
✓ Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
✓ Turn the cooker top upside down and
fasten the brackets “F and R” to the
appropriate socket holes, without tigh-
tening the screws “B” for the moment.
✓ Make sure that the brackets are faste-
ned as shown in figure 4.8.