Caple C995 - Manual (Page 11)

11
Electrical connection
• We recommend to connect the appliance with an outlet. In this way the technical assistance
interventions could be more simple.
• Make sure the outlet is available even after the appliance was collected.
• If the connection is not made by an electrical outlet, contact an electrician who is familiar with the
additional local codes and regulations issued by the utility area.
• The fitter may have to settle a switch in case the plug is no longer accessible after the built-in.
• This device must be at a suitable opening distance from the contacts in order to allow the entire
disconnection in case of overvoltage category III, in accordance with installation rules.
• The informations about the connection are found in the technical label, whose indications must
correspond to the electricity grid ones.
The manufacturer cannot be held liable for damage which is the direct or indirect result of
incorrect installation or connection.
It also cannot be held liable for damage caused by failure or interruption of the grounding.
After the installation every part of the appliance must be isolate so cannot happen accidents while
the operation
Absorbed power
Look at technical label
Connection and protection
AC 230 V/ 50 Hz
Overload switch 16 A
Differential switch (safety switch)
For more security we recommend to predispose a differential automatic switch (safety switch).
Remove the appliance from the power grid
To remove the appliance from the electric line proceed as described below:
- Fuses
Pull out the fuses from their supports, or:
- Automatic protection
Press the control button (red one) until comes out the central button (black one), or:
- Protection from the embedding
Move the switch from 1 (insertion) to 0 (disconnection), or:
- Automatic differential switch (safety switch)
Move the principal switch from 1 (ignition) to 0 (shut down) or press the control buttom
After detachment make sure that the grid cannot be reinserted
Replacement of the power cable
In case of demagement of the power cable, it must be replaced with H 05 VV-F cable type.
The replacement need to be installed by a Caple service agent.
SAFETY INSTRUCTIONS FOR INSTALLATION