DeLonghi KBM 1511 - Manual

BEFORE USE
• Remove all packaging from the kettle and power base.
• Remove any labels from the outer stainless steel surfaces.
• Remove the filter (fig. 1) and wash with water (fig. 2). Refer to page 8. “Removing the water filter”
• Fill the kettle with water, plug power cord into outlet and turn the unit “ON” (for details see
“Switching On”).
• The boiled water should be discarded and the kettle rinsed out with cold water. This
procedure should be carried out three times, to remove any manufacturing dust, etc.
• After the kettle has been rinsed out, replace the filter (fig. 3).
IN USE
Power base with 360° access
With the specially designed power base and central connector, you
can now set the kettle on the base at any angle, from any position.
• Release cord from storage base and adjust length by winding
around the base to give the correct cord length to reach the
outlet to be used (fig. 4).
• Do not leave loose cord hanging over the edge of work surfaces.
Filling
• Remove the kettle from the base unit before filling.
• Open lid and fill kettle to desired level.
In some models, a handy external water level indicator (I)
enables you to see the quantity of water in the kettle.
Do not fill with less than 0,25 liters(10-Ounces) of water
to
prevent the kettle running dry while operating; misuse of this
kind will shorten the life of the element.
Do not fill with more than 1,7 liters (58-Ounces) of water
(up
to the MAX indication located inside the kettle) (fig. 5). If the
kettle is overfilled, there is a risk that boiling water may be
ejected causing burns.
A handy water level indicator enables you to see the quantity of
water in the kettle.
6
a
c
b
1
2
1 2 3
4
MAX 1.7
5
MAX 1.7
MIN 0.25
5
Lt
Lt