Dell Emphasis Lighting Control System User Manual
Page 16
12
Emphasis Control System Quick Guide
Step 16: Press [Enter]. The Facepanel will boot and the Stage displays will open on the
attached monitor(s).
Installing Software on the Emphasis Server
If you are installing a new version of software, you will be provided specific instructions for
installation with the release notes for that version. When installing Emphasis software, you
are given the opportunity to install only Emphasis program files (located on the C drive) or
to install a full disk image for both the C and D drives.
C A U T I O N :
Installing a full disk image for the C and D drives will delete show files stored on the
Emphasis Server.
It is highly recommended to backup all show files before loading new software. To backup
existing show files see
To install software:
Step 1:
Power up the Emphasis Server.
Step 2:
When the Dell screen appears, press F12.
Step 3:
Insert Emphasis Software CD #1 into the CD drive on the Emphasis Server.
Step 4:
Press “4” to select Boot from IDE CD ROM and press ENTER.
Step 5:
A warning screen appears allowing you to choose to continue or cancel:
•
If you want to continue with the installation process, press any key.
•
If you want to cancel the installation process, Press CTRL+C. When
prompted to “Terminate batch job (Y/N)?”, press “Y”. The DOS prompt will
appear. You may restart the Emphasis Server (press CTRL+ALT+DELETE)
at this point for normal operation.
Step 6:
The installation type screen appears. Choose the type of installation you want to
perform:
•
Install Emphasis Program files only (press “E”). This option restores the disk
image of the C drive only, show files are retained.
•
Install full disk image (press “A”). This option restores the disk image of the
C and D drives, show files are deleted.
C A U T I O N :
Installing a full disk image for the C and D drives will delete show files stored on the
Emphasis Server.
Step 7:
After you press “E” or “A”, the disk image begins to load from the Emphasis
Software Disk #1. You will be prompted to load subsequent disks by the disk
utility. Eject the first disk and load the next disk and press ENTER.
Step 8:
When completed, you will be prompted to remove the final CD from the drive and
restart the Emphasis Server. You can restart the Emphasis Server by pressing
the power button twice, or by pressing CTRL+ALT+DELETE.
Step 9:
After a new version of software has been installed on your Emphasis Server, you
will need to install Facepanel Software. See
Installing Facepanel Software, page
, for that procedure.