Comtech EF Data CDM-625 DC-AC Conversion - Manual

CDM-625 DC-AC Conversion Instructions
MN-625DCAC00FRI Rev A Page 1 of 4
Copyright © Comtech EF Data Corporation, 2012. All rights reserved.
This document gives instructions for converting a CDM-625 DC Chassis into a CDM-625 AC Chassis
without an IP Packet Processor Card.
The area of assembly is in the rear right corner of the chassis where the power supply and power switch
are located. See the picture below for reference.
Instructions:
1. Turn power off; remove the power cord and the top cover. See picture below.
Turn off switch
Remove power cable
and top cover