Comtech EF Data SMS-301 - Manual (Page 90)

Remote Control Operation SMS-301 Redundancy Switch
A-8 Rev. 3
A.6 Status Commands/Responses
Modulator
Config.
Status Command:
Response: <add/MCS_'cr'
>add/MCS_'cr'
MODE_xxxxxx'cr'
SM_xxx'cr'
MA_yyy'cr'
MD_yyy.y'cr'
ADD_A_yyy'cr'
ADD_B_yyy'cr''lf']
Operation Mode
Switching Mode
Modulator's Active
Modulator/Modem Delay
A Modem Address
B Modem Address
The Modulator configuration status command causes a block
of data to be returned by the SMS301.
Note: *1* = dependent mode only, *2* = independent mode
only.
Demod
Config.
Status Command:
Response: <add/DCS_'cr'
>add/DCS_'cr'
MODE_xxxxxx'cr'
SM_xxx'cr'
DA_yyy'cr'
+ DD_yyy.y'cr'
# MD__yyy.y'cr'
ADD_A_yyy'cr'
ADD_B_yyy'cr''lf']
Operation Mode
Switching Mode
Demodulator's Active
Demodulator Delay
Modem Delay
A Modem Address
B Modem Address
The Demodulator configuration status command causes a
block of data to be returned by the SMS301.
+ Note: Status only returned in Independent Mode.
# Note: Status only returned in Dependent Mode.
Modulator
Status Command:
Response: <add/MS_'cr'
>add/MS_'cr'
MOD_A_xxx'cr'
MOD_B_xxx'cr''lf']
A Modulator Status (OK/FLT)
B Modulator Status (OK/FLT)
The Modulator status is returned as a block of data which
provides fault information of all 'active' Modulators.
Note: Response shown is for a system with all possible
modulators active. Only active modulator status will be
reported.
Demod
Status Command:
Response: <add/DS_'cr'
>add/DS_'cr'
DMD_A_xxx'cr'
DMD_B_xxx'cr''lf']
A Demodulator Status (OK/FLT)
B Demodulator Status (OK/FLT)
The Demodulator status is returned as a block of data which
provides fault information of all 'active' Demodulators.
Note: Response shown is for a system with all possible
demodulators active. Only active modulator status will be
reported.