Comtech EF Data CRS-311 - Manual (Page 47)

CRS-311 1:1 Redundancy Switch Revision 7
Installation MN/CRS311.IOM
2–5
Tools needed to install the KT/6228‐2 (4”) or KT/6228‐3 (10”) Bracket Kit (Figure 2‐3):
• A medium Phillips™ screwdriver
• A 5/32‐inch SAE Allen™ Wrench
• An adjustable Crescent™ wrench
Typical for all products, follow these steps to install the Rear‐Mounting Support Brackets Kit:
Step Task
1
Use the #10 flat washers, split washers, and hex nuts (Items 2, 3, and 4) to secure the shoulder
screws (Item 1) to the modem chassis through the rear right and left side mounting slots.
2
Use the #10 rear support bracket bolts (Item 5) to install the rear support brackets (Item 6) onto
the rack enclosure threaded rear mounting rails.
3
Mount the modeminto the rack enclosure: First ensure that the shoulders of the #10 shoulder
screws properly engage into the rear support bracket slots. Then, slide the unit into its stored
position.
4
If needed, secure the front panel to the rack enclosure threaded front mounting rails with user-
suppllied screws as shown in Figure 2-2.