Comtech EF Data SDM-300A User Manual
Page 423
SDM-300A Satellite Modem
Revision 6
Remote Control Operation
MN/SLM3650.IOM
A–31
MTIT_6_yyyyy'cr' (Note
5)
MTCP_6_yyy'cr' (Note
5)
MTDP_6_yyy'cr' (Note
5)
MTMD_6_yyyyy'cr' (Note
5)
MTAF_6_yyy'cr' (Note
5)
MTDR_7_yyyyyy'cr' (Note
5)
MTIT_7_yyyyy'cr' (Note
5)
MTCP_7_yyy'cr' (Note
5)
MTDP_7_yyy'cr' (Note
5)
MTMD_7_yyyyy'cr' (Note
5)
MTAF_7_yyy'cr' (Note
5)
MTDR_8_yyyyyy'cr' (Note
5)
MTIT_8_yyyyy'cr' (Note
5)
MTCP_8_yyy'cr' (Note
5)
MTDP_8_yyy'cr' (Note
5)
MTMD_8_yyyyy'cr' (Note
5)
MTAF_8_yyy'cr' (Note
5)
TRSI_xx'cr'
T310_xxx'cr'
G7LT_xxxxx’cr’ (Note
11)
RF_xxx'cr''lf']
Mux Tributary #6 Interface Type
Mux Tributary #6 Clock Phase
Mux Tributary #6 Data Phase
Mux Tributary #6 Mode
Mux Tributary #6 Async Mode
Mux Tributary #7 Data Rate & Enable
Mux Tributary #7 Interface Type
Mux Tributary #7 Clock Phase
Mux Tributary #7 Data Phase
Mux Tributary #7 Mode
Mux Tributary #7 Async Mode
Mux Tributary #8 Data Rate & Enable
Mux Tributary #8 Interface Type
Mux Tributary #8 Clock Phase
Mux Tributary #8 Data Phase
Mux Tributary #8 Mode
Mux Tributary #8 Async Mode
TX Reed-Solomon Interleave Value
TX 8PSK 2/3 IESS-310 Operation
G.703 Unbalanced or Balanced
RF Output (ON/OFF)
Note: This command is used by the Comtech EF Data M:N
protection switch to collect information that is necessary to
configure back-up modems. Because this command (content
and/or order) can be changed at any time by Comtech EF Data, it
is advisable that other commands ('MCS_' and 'ICS_', or 'BCS_')
be used for M&C systems.
Notes:
1. Data is only returned for TX D&I Overhead (or Flex Mux D&I).
2. Data is only returned for TX IDR Overhead.
3. Data is only returned for TX ASYNC Overhead
4. Data not returned if Local AUPC is enabled & TX ASYNC overhead.
5. Data is only returned if MUX PCB (Card Slot #1) is installed.
6. Data is only returned if FLEX MUX PCB (Card Slot #1) is installed.
7. Data not returned if Channel #1 is disabled (with Flex Mux PCB installed)
8. Data not returned if Channel #3 is disabled or set for AUPC.
9. Data not returned if Channel #4 is disabled or set for AUPC (with Flex Mux PCB installed).
10 Data is only returned for TX ASYNC Overhead( or Flex Mux AUPC).
11 Data is only returned if G.703 Personality PCB is installed.