Comtech EF Data MD2401 - Manual (Page 55)

MD2401 L-Band Multi Demod Installation and Operation Manual User Interfaces
MN-MD2401 4–23
Revision 7
*<2>
*<2>
*<1>
*<1>
*<30>
*<1>
*<1>
*<1>
*<30>
*<1>
<1>
Receive ESC
Audio #1 Volume
Receive ESC
Audio #2 Volume
Alarm 5 Mask
Insert Mode
Insert Map
Insert Alarm Mask
Insert Back Alarm
Mask
Force Terrestrial
Back Alarm
Insert Edit Map
Rx Impedance
1
TPC Interleaver
4.6 If G.703 Daughter Card Installed
0 = G.703 Unbalanced E1, 1 = G.703 Balanced E1, 2 = G.703 T1,
B8ZS
If synchronous Multiprotocol daughter card is installed:
0 = V.35, 1 = RS-422, 2 = RS-232
Note: The following two bytes apply only if an IDR OR IBS
interface card is installed and the Receive Mode is set to IDR
Mode. If not, ignore
-20 to +10, Signed Binary Value in dB
Note: The following two bytes apply only if an IDR OR IBS
interface card is installed and the Receive Mode is set to IDR
Mode. If not, ignore
-20 to +10, Signed Binary Value in dB
Bit 0 = IBS Satellite Multiframe Fault
Bit 1 = IBS Satellite Frame Fault
Bit 2 = Spare
Bit 3 = IBS Alarm if BER < 10-03
Bit 4 = IBS Prompt Alarm
Bit 5 = IBS Service Alarm
Bit 6 = Turbo Codec Lock Fault
Bit 7 = Spare
(0 = Mask, 1 = Allow)
0 = Disable, 1 = T1-D4, 2 = T1-ESF, 3 = PCM-30, 4 = PCM-30C, 5 =
PCM-31, 6 = PCM-31C, 7 = T1-SLC96, 8 = T1-D4-S, 9 = T1-ESF-S
Mapping of Satellite Channels to insert Terrestrial Timeslots
Bit 0 = Frame Lock Fault
Bit 1 = Multiframe Lock Fault
Bit 2 = CRC Lock Fault. Valid only in T1-ESF and E1 – CRC enabled
Bit 3 = T1 Yellow Alarm Received
Bit 4 = E1 FAS Alarm Received
Bit 5 = E1 MFAS Alarm Received
Bit 6 = E1 CRC Alarm Received
Bit 7 = CRC Calculation Fault
(0 = Mask, 1 = Allow)
Bit 0 = Backward Alarm Received from Satellite
Bits 1 – 7 = Spares
(0 = Mask, 1 = Allow)
Force D&I Terrestrial Backward Alarm to be Trans
(0 = Not Forced, 1 = Forced)