Comtech EF Data IPSat GW1000 - Manual (Page 41)

31
01-0945-401 Rev A 08/2004
Appendix B
Cable Specifications
This appendix provides installation procedures and defines the required performance parameters for the following
cables and connectors:
• IFL TX and Rx cables
• Y-cable
• Optional Power Detector Cable
• IFL F- and N- connectors
IPSat GW1000 Cabling
IFL Cables
IFL cables must conform to the specifications provided in this manual to ensure that ComStream equipment operates
properly.
Quad-shielded coax must be used for IFL cables. Without quad shielding, the system may be subject to outside RF
interference, which can degrade performance.
IFL cables must be properly installed for the system to operate at the specified performance levels. Radyne
ComStream strongly recommends purchasing the following IPSat GW1000 IFL cables from the following vendors:
• LMR-400 quad-shielded coaxial cable, Times Microwave Communications, 800-867-2629
• RG-11 quad-shielded coaxial cable, type 2282, Times Fiber Communications, 800-677-2288
It is assumed that the TX and Rx IFL cables are the same length. A record of the length of these cables should be
kept for reference. Radyne ComStream can provide complete IFL Kits including all required connectors and cables
pre-wired...