Comtech EF Data LPOD-R - Manual (Page 126)

LPOD-R Outdoor Amplifier / Block Up Converter (BUC) MN-LPODR
Optional Serial-based Remote Product Management Revision 1
5–16
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are printable ASCII characters)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
Query
(Target to
Controller)
Retrieve next
5 unread
Stored
Alarms E
(cont)
Example: <1/LNA?’cr’
>0001/LNA=’cr’
LOG CLR IF 175503 052307’cr’
FAN #1 FT 175504 052307’cr’
OVR TMP FT 175504 052307’cr’
FAN #1 OK 175504 052307’cr’
IIC BUS FT 175504 052307’cr’’lf’
Notes:
1) If there are no events in the log the unit will reply with LNA*.
2) All events that are read from the log are also automatically removed from the log.
Low forward
Power
Threshold
LPT= 5 bytes Command or Query.
Sets or returns the threshold for the low forward power alarm/fault in the form xx.xx.
Default Value: 00.00
Example: <1/LPT=00.00’cr’
>0001LPT=’cr’’lf’
Notes:
1) If there are no events in the log the unit will reply with LNA*.
2) All events that are read from the log are also automatically removed from the log.
3) Setting this parameter to 00.00 effectively disables the threshold
LPT =
LPT?
LPT *
LPT? LPT =xx.xx
(Same format as
command
arguments)
Local/Remote
State
LRS= 1 byte Command or Query.
Sets or returns the Local or Remote state for the Indoor SSPA in the form x, where:
0 = Local
1=Serial
2=Ethernet
3=Serial+Ethernet
Default Value: 3 (Serial+Ethernet)
Example: <1/LRS=3’cr’
>0001/LRS=’cr’’lf’
Notes:
1) Use this command to limit changes from being made on multiple interfaces at the same time.
2) State is always in remote mode for Outdoor SSPAs such as the LPOD-R.
3) The LRS command is available in all modes as a means of acquiring control. You will always have query access in
any mode.
4) The LPOD-R treats LRS=0 as reserved, and refuses the command by returning a mode error.
5) The Web server interface is inoperable unless LRS is set to enable Ethernet remote control.
LRS=
LRS?
LRS? LRS=x
(Same format as
command
arguments)