Crate FW120H - Manual (Page 7)

FlexWave120H Guitar Amplifier w/DSP and Channel Tracking
7
The DSP Section
Signal Path
MOD + DELAY + REVERB
Effect Setting Description
Chorus 1 Chorus with low depth
Chorus 2 Chorus with medium depth
Chorus 3 Chorus with high depth
Flanger 1 Flanger with low depth
Flanger 2 Flanger with medium depth
Flanger 3 Flanger with high depth
Phaser 1 Phaser with low feedback
Phaser 2 Phaser with medium feedback
Phaser 3 Phaser with high feedback
Slap 1 Single short delay with low level
Slap 2 Single short delay with medium level
Slap 3 Single short delay with high level
Medium 1 Multiple repeats with low level and medium length
Medium 2 Multiple repeats with medium level and medium length
Medium 3 Multiple repeats with high level and medium length
Long 1 Multiple repeats with low level and long length
Long 2 Multiple repeats with medium level and long length
Long 3 Multiple repeats with high level and long length
4. DELAY: Use this control to select the
type of digital delay effect. In its fully coun-
terclockwise position, the signal will be “dry”
(without delay). As you rotate the control
clockwise, you can select from three slap
settings, three medium delay settings, or
three long delay settings. The chart below
describes these effects.
5. MOD: Use this control to select the
type of digital modulation effect. In its fully
counterclockwise position, the signal will
be “dry” (without modulation). As you rotate
the control clockwise, you can select from
three chorus settings, three flanger settings,
or three phaser settings. The chart below
describes these effects.
6. REVERB: Use this control to adjust the
amount of digital reverb effect. In its fully
counterclockwise position, the signal will
be “dry” (without reverb). As you rotate this
control clockwise, the amount of reverb
increases.
DELAY
CD
MOD REVERB
EFFECTS
SLAP LONG
MEDIUM
CHORUS PHASER
FLANGER
4 6 5