Crate V33-212 - Manual (Page 5)

V33-212 Tube Guitar Amplifier with Reverb
5
The Rear Panel
15. AC LINE CORD: The grounded power
cord should only be plugged into a
grounded power outlet that meets
all applicable electrical codes, and is
compatible with the voltage, power, and
frequency requirements stated on the
V33-212 rear panel. Do not attempt to
defeat the safety ground connection.
16. Voltage Select Switch: Set this switch
to “115” for 120 VAC mains, and to
“230” for 220-240 VAC mains.
With the amplifier power cord
unplugged, use the tip of a small flat-
blade screwdriver to slide this switch to
the proper position.
17. FOOTSWITCH Jack: Use this 1/4"
TRS jack to connect the cable of the
optional VSFS-2 footswitch. This allows
for remote control of channel switch-
ing and the boost effect (Tip= channel
select, Ring = boost on/off).
18. EFFECT SEND: Use this 1/4" TS jack
to send the signal to an external effects
box.
Note: The Effect Send jack can be
used as a line-level output from the
preamplifier stage of the V33-212 to
a mixer or recorder. The signal comes
after the EQ stage but before the
reverb stage.
19. EFFECT RETURN: Use this 1/4" TS
jack to return the signal from an exter-
nal effects box.
Note: The Effect Return jack discon-
nects the signal from the preamplifier
stage of the V33-212, so only the sig-
nal at the Effect Return jack is sent on
to the power amplifier.
20. EXTENSION SPEAKER: Use this 1/4"
TS jack to connect the amplifier to an
8 ohm extension speaker. The internal
speaker remains active when an exter-
nal speaker is connected.
21. SPEAKER 8 OHMS: The V33-212 is
shipped with a cable connected from
this jack to the internal speakers.
22. REVERB IN Jack: The V33-212 is
shipped with a cable connected from
this jack to the input of the internal
spring reverb.
23. REVERB OUT Jack: The V33-212 is
shipped with a cable connected from
this jack to the output of the internal
spring reverb.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
US C
3031613 CONFORMS TO IEC 60065
~100-240V 50-60 Hz 120W N222
ROHS
SERIAL NUMBER MANUFACTURING DATE
AVIS: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
c 2007 LOUD TECHNOLOGIES INC
DESIGNED IN ST.LOUIS MO, USA. MANUFACTURED IN CHINA, FABRIQUE EN CHINE
FOOTSWITCH EFFECT
SEND
EFFECT
RETURN
EXTENSION
SPEAKER
SPEAKER REVERB
IN OUT 8 Ohms
115
15 16
17 18 19 20 21 22 23