CREATOR CAT5 - Manual (Page 26)

CREATOR CHINA 2013-08 WWW.CREATOR1997.COM
The second generation Digital CAT5 transmitter User 's Manual 20
Model
Parameters
CR-uCAT5 VGA 200R Transmitter
Gain 0dB
Frequency response 20Hz~20KHz
Total harmonic
distortion + noise
0.01%@1kHz( under constant voltage)
S/N ratio(S/N) >80dB at Vin=0V
CMRR >75dB @:20 Hz~20 kHz
Signal type Stereo (unbalanced connection)
Impedance
Input:>10kΩ(balanced or unbalanced connection)
Output:50Ω(unbalanced connection)
Maximum input level +19.5dBu, (balanced or unbalanced connection)
Gain error ±0.1dB @20 Hz~20 kHz
Port control
Serial port control
RS-232(3.5MM earphone socket)
Baud rate 110-115200bps
Infrared control
Infrared control
IR(3.5MM earphone socket)
IR frequency 38KHz
HDBaseT input interface
Interface High speed RJ45
Transmission
distance
Up to 100m via CAT5e/6 shielding cable
Specification
Power supply
12V/1.5A DC adapter
Maximum power
dissipation
11.5W
CR-uCAT5 VGA 200R receiver supports any resolution of the transmitter output. In order to achieve
the best display effect, we suggest set its resolution the same as the recommended resolution of the
terminal display device. If it is used together with CR-uCAT5 AV 200T transmitter, user can adjust the
output resolution of transmitter. With HDMI,DVI transmitter, user can directly regulate the output
resolution of the source.
2.7.7 CR-uCAT5 AV 200T Transmitter Engineering Serial Instruction Sets
Model
Parameters
CR-uCAT5 AV 200T Transmitter
Serial protocol:Baud rate:9600 Data bits:8 Stop bit:1 Parity:no
Instructions Function description
Video Switch Command:
01$01!
CV video switch out
02$01! YC video switch out
03$01! YUV video switch out