Crest Electronics CRE57004SD TRAIN ENGINEER BASE STATION SET - Manual (Page 4)

For more info on the Base Station visit the above web site and under
support look for CRE57005S Manual .
To operate the locomotive on your layout press the Fast button on the transmitter
and your locomotive will starts to move.
Note: A default (49) will show on the Link / Bind address also SU. To change the
numbers to '00' press the Stop/Enter button to bring the number down to the
(00) designation. It's recommended to start your layout/ locomotive by choosing
your CAB -0 and Link Address 00. Refer to the manual on the CD for more info.
If the Transmitter shows an overload or overheat signal on the LCD, make sure
there are no shots the track or locomotive. When all is cleared press the “0 all
stop” button to reset this function.
When the RED button is pressed and solid blue light is on the receiver turn off the
power on the power supply and turn it back on to reset the linking process.
4