Ducati MOTORHOLDING 800SPORT - Manual (Page 59)

59
E
The height of the light beam can be corrected using
the screw (1, fig. 66) on the left side of the headlamp.
Turn the screw clockwise to lower the beam,
anticlockwise to raise it.
The side position of the headlamp is adjusted using
the adjusting screw (2, fig. 66) on the right side of
headlamp. Turn the screw clockwise to move the beam
to the right, anticlockwise to move it to the left.
Tyres
Front tyre pressure:
2.1-2.2 bar
Rear tyre pressure:
2.1-2.3 bar
As tyre pressure is affected by temperature and altitude
variations, you are advised to check and adjust it
whenever you are riding in areas where ample variations
in temperature or altitude occur.
Important
Check and set tyre pressure when tyres are cold.
To avoid front wheel rim distortion, when riding on
bumpy roads, increase front tyre pressure by 0.2 - 0.3
bar.
RIGHT
1
2
LEFT
RIGHT
2
LEFT
LOWER
UPPER
fig. 66