Cybex 13030-999 VR1 Row User Manual

Page 13

Advertising
background image

Cybex Owner’s Manual

13

2. Position each weight plate so wide edges of bushings face upward and narrow edges

of bushings face downward.

CORRECT

Wide bushing

edge faces upward

The narrow bushing edge

must face downward.

WRONG

3. Install lifting post.
4. Snap guide rods into position.

Cable routing

1. Verify cable is routed through top of pulley bracket and then route cable end to top weight

connector.

2. Pull cable tight and secure in place with spiral pin using a 3/16” pin punch and a hammer.

Cable End

Top Weight

Spiral

Pin

3. Place weight stack pin in each plate to verify proper installation.
4. Lift top weight up and down simulating normal operation (without selecting any resistance).
5. Verify that the cable is moving smoothly and is routed straight from the pulley bracket to the

top of the weight plate connector.

Install back shroud

1. Place shroud into position.
2. Secure top in place using two BHSCS and 7/32” Allen wrench.

Verify proper operation

Advertising