D.T. Systems H2O 1810 PLUS with SmartLED - Manual (Page 8)

8
PARTS & FUNCTIONS
Buttons #1 & #2 (H
2
O 1830 PLUS only) - Pressing
the Jump Button (#1) makes the collar give a ‘Jump’
Stimulation, making the intensity level instantly “jump”
to a user-programmed intensity level (see page 19).
Pressing the Rise Button (#2) makes the collar give a
stimulation that gradually increases in intensity level
the longer the Rise Button is pressed.
Buttons #1 & #2 (H
2
O 1850 PLUS only) - Pressing
the Locate Button (#1) makes the Beeper Horn emit a
loud beep. Pressing the Run/Point Button (#2) acti-
vates the Run & Point mode on the Collar Receiver.
Pressing the button again changes the mode to the
Point Only mode. Pressing the Locate Button cancels
the Run/Point modes.
Battery Charging Receptacles - The battery
charging receptacles are located on the side of the
Transmitter and on the side of the Collar Receiver
facing the dog’s neck. After charging, always close
the jack with the rubber plug to prevent foreign
particles from getting inside the unit.
NOTE
The unit is still waterproof even if water gets into the charg-
ing receptacle. However, if water should get in, we recom-
mend rinsing out the charging receptacle and allowing it to
dry, especially after use in salt water. This will prevent pre-
mature corrosion in the metal pins inside that make contact
with the charger plug.