Daktronics MS-2013 Portable LED Scoreboard - Manual (Page 12)

6 Mechanical Installation
There are three height-adjustment holes in the support tubes on the sides of the scoreboard.
Raise the scoreboard for viewing by removing the pins and retaining clips, sliding the
scoreboard upward on the T-stands and reinserting the pins in the appropriate holes. Lower
the scoreboard for storage or transportation. It may be helpful to have one person lift the
scoreboard while another person adjusts the locking pins.
Caution! Do not raise the scoreboard in high winds or transport the scoreboard in the raised
position. These actions increase the likelihood of tipping over and damaging the scoreboard.
3.3 Optional Equipment Installation
Reference Drawings:
Caption Options, MS-2013 .................................................................................... A-159890
Cover Installation- MS-2013 .................................................................................. A-160060
Ad Panel Installation, MS-2013.............................................................................. A-160057
Caption Kits
The MS-2013 is shipped as a generic multisport scoreboard with a standard clock/score
caption arrangement. The face of the scoreboard displays game time, home and guest scoring,
and period. Four optional caption kits give the scoreboard added versatility:
 Custom Team Names
 Baseball/Softball Mode
 Segment Timing Mode
 Volleyball Mode
The aluminum caption panels are applied to the scoreboard face with hook-and-loop fastener
strips. They can be easily removed and replaced for various events, leaving the hook strips
attached to the face of the scoreboard. Refer to Drawing A-159890 in Appendix A for an
illustration of the various caption configurations.
Scoreboard Cover
The aluminum cover protects the MS-2013 during transportation and storage. Flanges on the
cover fit into slots on either side of the scoreboards, and the cover simply slides into place
using handles on the front. Drawing A-160060 in Appendix A illustrates the cover installation.
Note: If a radio antenna is installed on the face of the scoreboard it is highly recommended
to remove the antenna before installing or removing the cover. Refer to Section 4.3 for
more information about radio installations.
Ad Panel
A custom advertising/school logo panel may be added to the MS-2013. Threaded inserts in the
top of the scoreboard cabinet allow attachment using only three screws. The 12" H x 52" W
(305 mm, 1.32 m) aluminum panel runs the full width of the scoreboard. Drawing A-160057 in
Appendix A illustrates the ad panel installation.