Daktronics Protective Screen - Manual

ED-5423 Rev 9 – 10 September 2010
Tuff Sport ® is a registered trademark of Daktronics, Inc.
Protective Screen Installation Instructions
Shot Clocks & Small Scoreboards
Refer to Drawing A-141025 during assembly and installation.
1. Attach the mounting angles to the top and bottom of the display using the short screws.
2. Attach screen extension tubes to angles with longer screws.
3. Lift the screen into place and secure between the tubes with the ½" diameter pins provided.
4. Insert the spring clips into the end of the mounting tube, through the hole near the head of the pin.
Tuff Sport
®
Scoreboards & Statistic Displays
Refer to Drawing A-150635 during assembly and installation.
1. Attach angle brackets to the scoreboard using the short screws through the holes in the
scoreboard frame and threaded into the brackets.
2. Insert the long screws through the extension tubes and attach to the brackets.
3. Position the screen between the extension tubes and insert the pins through the ½" holes in the
extension tubes and into the ½" holes in the top and bottom of the screen frame.
4. Secure the pins with the hair pin cotters, inserted through the front of the extension tubes.
5. If wires are to be routed through the large hole in the bracket, install a 1.5" bushing in the hole
before inserting wires.
Wall Mounting
Refer to Drawing A-56802 during assembly and installation.
1. Attach wall mounting brackets to wall as required to fit protective screen.
2. Attach extension tubes to wall mounting brackets.
3. Fit screen between extension tubes and insert pins through holes in extension tubes and
protective screen frame.
4. Secure pins inserted into the protective screen frame, with clips, engaging the hole near the head
of the pin.
Note: To gain access to the scoreboard for service, remove the pins from one side and swing the screen
out, pivoting on the pins on the other side.