Daktronics FL-3000 and FL-4500 FuelightTM 36- and 48-Inch Petroleum Display - Manual

FL-3000 and FL-4500 Fuelight TM 36- and 48-Inch
Petroleum Display Installation Quick Guide Page 1 of 6
DD2766540 Rev 00
25 June 2014
PO Box 5128 201 Daktronics Drive, Brookings, SD 57006-5128
tel: 800-325-8766 fax: 605-697-4700
www.daktronics.com
Connecting Display Sections
FL-3000 and FL-4500 36- and 48-inch displays come in two, three,
or four sections that must be connected to one another before
installation on a sign structure or in a sign cabinet.
1. Open digit doors in each section by gently turning the
slotted latches on each door counter-clockwise with a flat-
head screwdriver.
2. Join the sections together in the designated locations with
3/8-16 bolt, lock washer, and nut, as shown in Figure 1.
3. Route signal interconnect cables using the 1.50" holes in
each section, as shown in Figure 2.
4. Close and latch the doors of each section securely.
Installing the Display Inside a Sign Cabinet
Design a space in the sign for the display so that the front of
the Fuelight
™ display cabinet is flush with the front of the sign,
allowing the doors to protrude ½" [12.5 mm].
Consult Drawing B-1154438 for more
detailed information regarding sign
cabinet requirements. Use the display shop
drawing to locate mounting holes used in
this installation type.
1. Lift the display into the support
structure. Figure 3 shows a display
being inserted into a support
structure.
Note: Daktronics assumes no
liability for display damage or
injury resulting from incorrect
setup or incorrect lifting methods.
2. Use 3/8-16 bolts and the four mounting holes in each section to attach the
display to the sign cabinet. Actual site demands will dictate variances and
appropriate mounting methods.
3/8-16 Bolt
Lock Washer
Nut
Figure 1: Secure Display Sections Together
Figure 2: Route Cables Between Display
Sections
Corner Gas
Figure 3: Inserting Fuelight Display
Into Custom Cabinet