Daktronics Fuellight Display - Manual

Fuellight
TM
Display Installation Quick Guide 1 of 2
PO Box 5128 201 Daktronics Dr Brookings SD 57006-5128
tel 605-697-4036 or 800-325-8766 fax 605-697-4700
www.daktronics.com
DD2109473 Rev 0
12 September 2011
For additional installation information, refer to Section 2, Section 3, and Section 4 of the display installation
manual.
Display Mounting
FL-2000 and FL-4000 Displays
1. Mount the display by sliding it into the support structure.
2. Drill through the front flanges of the cabinet to attach the display to
the base of the structure.
3. Remove all metal shavings from the display.
4. Make sure the front of the display is not enclosed so it receives
proper ventilation.
FL-2100 Displays
1. Use all eyebolts and a lift bar to lift the display into position on the
support structure, as shown in Figure 1.
2. Drill through the display cabinet to attach the mounting hardware.
3. Remove all metal shavings from the display.
4. If desired, remove the eyebolts.
5. Using silicone approved for use on aluminum, seal all holes on the display top.
6. Ensure the front of the display is not enclosed so it receives proper ventilation.
Note: Keep the display temperature below 140° F.
FL-2109 Displays
1. Lift the display into position on the support structure, as shown in Figure 1.
2. Weld or use 3 /
8
" hardened bolts to secure all clip angles to the support structure.
3. If desired, remove the eyebolts.
4. Using silicone approved for use on aluminum, seal all holes on the display top.
5. Ensure the front of the display is not enclosed so it receives proper ventilation.
Note: Keep the display temperature below 140° F.
Figure 1: Correct Lifting Procedures