Daktronics Sportsound Announcer’s Console - Manual (Page 3)

Sportsound Announcer’s Console Quick Start Guide
DD2222114 Rev 0
16 February 2012
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700
Web: www.daktronics.com
Wireless Receiver Operation
1. Press POwER to turn on the receiver. The display can show the
following information:
a) Group Number
b) Channel Number
c) Frequency
d) Transmitter Battery Status
e) Antenna Diversity Status
f) Audio Meter
g) RF Signal Strength
2. Perform a ClearScan: This function finds the clearest group and
channel with the press of a button. With nothing flashing, press
and hold SET until “CLEAR SCAN” appears on the right side of
the screen. When the scan is complete, the receiver will be set to
the clearest channel in the clearest group.
a b
c d
e f
g
For more information about the optional wireless receiver system operation and troubleshooting, refer to the wireless Microphone System User Guide.
Wireless Microphone or Bodypack Operation
1. Open the battery cover to expose the control buttons. Insert new or fully-
charged batteries prior to each use, and always have spares on hand.
2. Power on the unit.
3. Press SET and use the UP/DOwN buttons to modify the Group (GP)
number to match the receiver.
4. Press SET again and modify the Channel (CH) number match the receiver.
5. Press SET a third time to save the settings.
Note: Plug the antenna and mic into the jacks on top of the bodypack unit.
Verify Reception: With a transmitter and the receiver both turned on and
having matching Group and Channel numbers, the main receiver display
should be indicating an RF signal. Speak into the microphone and the Audio
Meter should indicate signal presence.
Power
ON/OFF
Control
Buttons