Daktronics Sportsound SSR-100 Quick Start Guide - Manual (Page 2)

Sportsound SSR-100 Quick Start Guide 2 of 3
DD2753515 Rev 1
23 January 2015
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/support
• For each input channel (source) in use, verify:
- SIG/OL light is green; if this light is red,
decrease the level
- ASSIGN is set to “A+B” or “B”
Note: Inputs set to “A” will only be heard
through the announcer’s console headphones.
This may be used to listen to each input
without interrupting the main mix.
• In the factory, the four stereo line inputs are set to MONO mode. This sends the signal to
both “A” and “B” outputs, and illuminates the amber LED. If MONO mode is disabled,
the input signal will only go to the output that matches the jack in the back of the mixer.
Audio Mixer Operation
REMEMBER: Bad input = bad output. No adjustment
on the mixer can make a poor source sound better.
For best results, be sure to use high-quality audio files
from your MP3 player or laptop, and set the device to
near full volume.
• Ensure all source equipment is turned on and operational.
If any optional wireless microphone systems are included,
refer to page 3.
• Adjust MASTER VOLUME “B” level to achieve the final output. If the OL light is red,
decrease the level.