DFI ST101-CP - Manual (Page 8)

8/9
2. The mounting holes are located
at the bottom of the system.
Mount the mounting rails on each
side of the system using the
mounting screws you have
purchased.
Mounting rail Mounting rail
3. Mount the whole system on the
wall by fastening screws through
the rail's mounting holes.
Rail's mounting hole
Note:
The pictures in this document are for illustration only. The system board and all
other components may differ depending on the configuration you have purchased.
Please refer to the provided DVD for details relevant to the system board.
Rail's mounting hole
Rail's mounting hole
Rail's mounting hole
Mounting ST101-CP (optional)
To mount the system on the wall, you need to prepare two mounting rails and
mounting screws.
1. If r ubber feet has been
previously attached at the
bottom of the system, please
remove them first.