DFI TPC121 Installation Guide - Manual (Page 19)

19
Mounting screw
Bracket
2. Remove these mounting screws and brackets, and
then put them in a safe place for later use.
3. Insert the Expansion card with a bracket into the slot
that is on the riser card. Replace the screw you
removed in step 2 to secure the bracket in place.
Installing the PCI and PCIe x1
Expansion Card
1. The PCI and PCIe x1 slots on the riser card are used to
install the expansion cards. To install the expansion
cards, you need to remove the mounting screws that
secure the brackets to the chassis then remove the
brackets.
PCI
PCIe x1
Expansion card
Note:
The Expansion card used in the illustration above may not resemble the
actual card. These illustrations are for reference only.