DFI NP100-N16C - Manual (Page 74)

74
3
BIOS Setup
USB Device Setting
Move the cursor to this field and press <Enter>. The following screen will ap-
pear.
Phoenix - AwardBIOS CMOS Setup Utility
USB Device Setting
Item Help
Menu Level

[Enable] or [Disable]
Universal Host
Controller Interface
for Universal Serial
Bus.
↑↓→← : Move Enter: Select F1: General Help +/-/PU/PD: Value F10: Save ESC: Exit
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
USB 1.0 Controller
USB 2.0 Controller
USB Operation Mode
USB Keyboard Function
USB Mouse Function
USB Storage Function
*** USB Mass Storage Device Boot Setting ***
Enabled
Enabled
High Speed
Enabled
Enabled
Enabled
USB 1.0 Controller
This field is used to enable or disable the Universal Host Controller Interface
(USB 1.0).
USB 2.0 Controller
This field is used to enable or disable the Enhanced Host Controller Interface
(USB 2.0).
USB Operation Mode
This field is used to select the USB’s operation mode. The options are Full/
Low Speed and High Speed.
USB Keyboard Function
Due to the limited space of the BIOS ROM, the support for legacy USB key-
board (in DOS mode) is by default set to Disabled. With more BIOS ROM
space available, it will be able to support more advanced features as well as
provide compatibility to a wide variety of peripheral devices.
If a PS/2 keyboard is not available and you need to use a USB keyboard to
install Windows (installation is performed in DOS mode) or run any program
under DOS, set this field to Enabled.
The settings on the screen are for reference only. Your version may not be identical to
this one.