DeLonghi BAR 32 - Manual (Page 11)

11
No milk froth is formed when
making cappuccino • Milk not cold enough.
• Jet Frother dirty.
• Always use skim milk at refrigerator
temperature.
• Thoroughly clean the holes in the Jet
Frother in particular those indicated
in figure 21.
PROBLEM POSSIBLE CAUSES SOLUTION
No espresso coffee is
delivered • Ground coffee too damp and/or
packed down too tightly.
• No water in the tank
• The holes in the filter holder spouts
are blocked.
• The espresso boiler outlet is blocked.
• The filter is blocked
• The tank is incorrectly inserted and
the valve on the bottom is not open.
The espresso coffee drips
from the edges of the filter
holder rather than the holes • The filter holder is inserted incorrectly.
• The espresso boiler gasket has lost
elasticity.
• The holes in the filter holder spouts
are blocked.
• Attach the filter holder correctly and
rotate firmly as far as it will go.
• Have the espresso boiler gasket
replaced at a service center.
• Clean the spout holes
The espresso coffee is cold • The espresso OK indicator light was
not on when the coffee switch was
pressed.
• No preheating performed
• The cups were not preheated
• Wait until the espresso OK indicator
light comes on.
• Preheat as described in the
paragraph "Preheating the espresso
coffee unit".
• Preheat the cups.
The pump is excessively noisy • The water tank is empty.
• The tank is incorrectly inserted and
the valve on the bottom is not open.
• Refill the tank.
• Press the tank down lightly to open
the valve on the bottom.
• Make the coffee again packing it
down less and/or using different
ground coffee.
• Fill the tank with water.
• Clean the spout holes
• Clean as described in the chapter
"Cleaning the boiler outlet".
• Clean as described in the section
"Cleaning the filter".
• Press the tank down lightly to open
the valve on the bottom.
The coffee froth is too
light (delivered from the
spout too fast) • The ground coffee is not pressed
down firmly enough.
• There is not enough ground coffee.
• The ground coffee is too coarse
• Incorrect type of ground coffee.
• Press the ground coffee down more
firmly (fig. 11).
• Increase the quantity of ground
coffee.
• Use ground coffee for espresso coffee
machines only.
• Change the type of ground coffee.
The coffee froth is too dark
(delivered from the spout too
slowly) • The ground coffee is pressed down
too firmly.
• There is too much ground coffee.
• The espresso boiler outlet is blocked.
• The filter is blocked
• The ground coffee is too fine.
• The ground coffee is too fine or is
damp.
• Incorrect type of ground coffee.
• Press the coffee down less firmly (fig.
11).
• Reduce the quantity of ground coffee.
• Clean as described in the chapter
"Cleaning the espresso boiler outlet".
• Clean as described in the section
"Cleaning the filter".
• Use ground coffee for espresso coffee
machines only.
• Use ground coffee for espresso coffee
machines only and make sure it is not
damp.
• Change the type of ground coffee.
EC190/200 GB 6-12-2004 12:38 Pagina 11