1 installing the handlebar, 2 installing the bag, 3 checking/adding motor oil – Echo Bear Cat WV190S 2009 User Manual

Page 9: 4 filling the tank, Warning, English

Advertising
background image

WHEELED VACUUM

5

ENGLISH

ASSEMBLY

2.1 INSTaLLING THE HaNdLEbaR

remove the two 7/8" plastic caps on the ends of the

1.

vacuum upper handlebar.
Position the upper handlebar over the lower handlebar

2.

as shown in figure 2.1. install using 5/16" x 1-3/4"

carriage bolts, flat washers and nylock nuts.
Tighten 5/16" hardware to 17 ft-lbs.

3.

using the cable ties from the owner's kit, secure the

4.

control cables to the machine.
See Section 4.4 for handlebar height adjustment.

5.

2.2 INSTaLLING THE baG

install the vacuum bag on the bag handle (figure

1.

1). Tighten the bag over the handle using the bag

buckle.
Place the loops of the vacuum bag into the bag hanger

2.

brackets.
lift the exhaust door.

3.

attach the bag handle to the vacuum discharge.

4.

2.3 cHEckING/addING moToR oIL

Check the oil level. if needed, fill the engine with the

type and amount of oil specified in the engine owner's

manual.

2.4 FILLING THE TaNk

use only those types of fuels that are recommended in

your engine owner’s manual.

To add fuel:

Stop engine, wait for all parts to stop moving and

1.

disconnect spark plug wire. remove key from key

switch. allow the engine and muffler to cool for at

least three minutes.
Clean area around fuel fill cap and remove cap.

2.

using a clean funnel, fill fuel tank to 1/2” below bottom

3.

of filler neck to provide space for any fuel expansion.

install fuel fill cap securely and wipe up any spilled

gasoline.

WaRNING

gasoline and diesel fuels are highly

flammable and their vapors are explosive.

To prevent personal injury or property

damage:
Store fuel only in approved containers,

in well ventilated, unoccupied buildings,

away from sparks or flames. A container

with a capacity of 2 gallons or less with a pouring spout

is recommended. Do not fill the fuel tank while the engine

is hot or running, since spilled fuel could ignite if it comes

in contact with hot parts or sparks from ignition. do not

start the engine near spilled fuel. Never use fuel as a

cleaning agent. do NoT Mix oil wiTh fuel.

Advertising