Eizo DuraVision FDS1904 取扱説明書 - Manual (Page 31)

11
En
gli
sh
3. Insert the electrical wires into the terminal block and tighten the clamp screws using a flathead screwdriver
with a tip width of 2.5 mm (recommended torque: 0.5 to 0.6 N•m).
The input polarities of the terminal block are shown below.
1 2
Pin No. Input Polarity
1 DC+
2 DC-
Flathead screwdriver
Clamp screw
Electrical
wire
4.
Secure the cable with a clamper to prevent disconnection.
For the signal cable
Clamper *1
*1 Clampers are not supplied with this product.
Please prepare separately.
For electrical wires
(DC power terminal block)