Elfa Drawer Frame - Manual

www.elfa.com
Sida 1 av 1
Drawer Frame
Assembly instructions
If you don’t have a plastic mallet, you can use a hammer with a wood block to protect the
frame. If assembling on tile or wood, you must protect the floor.
Tool needed: plastic mallet
NOTE
Step 1
– Position the side panels so the frame runners face
inward.
– Using a plastic mallet, tap the bottom T-crossbars into the
bottom of each side panel.
– If combining frames, see Figure B below.
Step 2
– If using a top shelf, tap the top L-crossbars completely
into each side panel. Place adhesive strips included in
the packaging on the top L-Crossbars. Align the top shelf
with the crossbars and press firmly.
Step 3
– Slide in drawers.
– If you have other frame and drawer accessories, install
them now.
Step 1
– Assemble the top frame completely. See steps 1-2 above.
Step 2
– Assemble the bottom frame, omitting the top L-crossbars.
Step 3
– Lower the top frame onto the bottom frame. Secure by
firmly tapping each corner of the top frame until the bottom
T-crossbars are completely inserted into the bottom frame.
Step 4
– Slide in drawers.
– If you have other frame and drawer accessories, install
them now.
Assemble a single frame
Combining drawer units
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: [email protected]