Elfa Ventilated Shelves - Manual

www.elfa.com
Sida 5 av 13
1
2
Wire Shelf and Bracket Cover
Snap in wire shelf, baskets and bracket cover
Install the wire shelves from shortest to longest, regardless of
their location in the space.
Wire shelves have a top and a bottom. The middle support
wire(s) is connected to the bottom of the shelf.
Install gliding components and hanging drawers before install-
ing wire shelves.
TIP
Install the wire shelves
Place the shelf wires over bracket click in notches.
Install the shelf with end wires inside the brackets.
Lock the shelf into place by pressing down on the middle
of the shelf and pushing toward the wall.
To REPOSITION a wire shelf after it’s been attached
to the brackets: Hold by the brackets, and lift the front
of the shelf toward the ceiling and outward to release
the entire unit from the hang standards. (Works on all
shelves except 20”/494 mm depth.)
To REMOVE a wire shelf from a bracket while on the
hang standards: Hold the hang standard steady with one
hand. Place the other hand at the back of the shelf. Pull
up and forward to release.
.
Install wire shelf baskets (not shown)
With the double wire front lip of the wire shelf
basket facing forward, place the wire shelf basket
wires over the bracket click in notches.
Install the wire shelf basket with the end wires
inside the bracket.
Lock the wire shelf basket into place by pressing
down on the middle of the wire shelf basket and
pushing toward the wall.
Insert wire shelf basket dividers where desired, if
applicable.
Bracket cover installation
Left and right bracket covers are not interchangeable.
Place the outer edge of the bracket cover over the
outer edge of the bracket click in.
Push down from the back to the front to snap the
bracket cover in place.
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: [email protected]