ENVIROMAC ESE 102 User Manual
Page 3
5)
Take the bottom motor wire of both motors and
join them together. You then connect these wires to
the white nylon terminal connector together.
6)
The single wire on the terminal board goes to
number 1 (#1) on the switch. The wire on the
bottom motor goes to number 2 (#2) on the switch
and the top motor wire goes to number 3 (#3) on
the switch.
The white wire on the power cord goes to the wire
on the terminal board that goes to #2 on the switch.
The black wire on the power cord goes to the single
wire on terminal that goes to the number 1 (#1) on
the switch. You can now put the switch and plates
back in place.
Preventative Maintenance
The brushes should be changed every 400 operating hours.
This procedure should become part of a preventative
maintenance program. This eliminates potential problems
with the commutator.
The 102.1007.001 filter has to be periodically replaced. The
suction will deteriorate as it loads up with particulate.