ETA Efektiv - Manual (Page 21)

- The manufacturer is not responsible for damage caused by improper use of a detergent,
the appliance and its accessories and its guarantee for the appliance does not apply
in situations when the safety warnings above have not been complied with. Failure to
replace or maintain all filters regularly according to the instructions in Chapter V., VI. and
also using non-original filters, the properties of which resulted in failure or damage of the
vacuum cleaner, is also understood to be improper use of the appliance.
II. EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER ETA – 0869 (Fig. 1).
A - MOTOR PART
A1 - handle A6 - power cord
A2 - START/STOP button A7 - accessories holder
A3 - locks A8 - anti-flow safety float
A4 - moulded jag for cable winding A9 - protective micro-filter
A5 - motor ventilation holes A10 - HePA filter
B - COLLECTION CONTAINER (volume - 4 l wet impurities / 6 l dry impurities)
B1 - suction vent
B2 - travel wheels
C - ACCESSORIES
C1 - floor nozzle
C2 - suction hose with end piece and handle
C3 - suction tube
C4 - nozzle with rubber spattle (for wet surfaces)
C5 - brush
C6 - crevice nozzle
C7 - nozzle for vacuuming wet impurities and liquids
Note
You can buy the optional TURBO nozzle for all types of vacuum cleaners.
III. VACUUM CLEANER PREPARATION
Remove all the packing material, take out the vacuum cleaner and the accessories. If the
accessories are placed in a container inside the vacuum cleaner, take them out from the
container. disassemble the vacuum cleaner by delicate bending of both locks A3 on the
sides of the vacuum cleaner and now you can take the motor part A from the container B.
Assemble the vacuum cleaner by putting the motor part on the upper edge of the container
and by slight push on the handle, the locking projections will be secured, accompanied with
the characteristic sound effect (snapping).
Assemble the vacuum cleaner according to selected type of cleaning (dry or wet) and
select the respective accessories (Fig. 2a, 2b).
Hose
- Connect the hose C2 to the vacuum cleaner by sliding the end piece to the suction vent
B1 and by turning the end piece clockwise to the maximum position (Fig. 5).
- Take out the hose by opposite movement.
For trouble-free operation of the vacuum cleaner, please use
tested micro-filters recommended by the producer.
21
GB