ETA Lancetta - Manual (Page 19)

DRIP STOP
The appliance prevents leaking water from the ironing plate when its temperature is
insufficient.
Safety electronics (aUTO STOP – applies for type ETa 2283 and ETa 6283/10)
The safety electronics ensure switching off heating of the ironing plate within 30 seconds
when the iron is left without moving in the horizontal position and in the case of tilting of
the iron on the side or within 10 minutes when it is left in the vertical position. The function
of safety electronics is signaled by control light flashing and by sound signal. The iron is
switched on automatically when ironing is continued.
Self-cleaning system (SELF cLEaN)
Hold the iron disconnected from power supply in your hand, turn steaming regulator D
to 0 position (Fig. 5) and lift off cover C to open the filling container lid. Pour water into
container I using the enclosed cup N to fill half of it and close the filling hole lid (Fig. 4)
by snapping it. Keep the position of the iron for pouring water in it. Put the iron to the
rest position (Fig. 7) and set the regulation wheel H to the maximum position.Plug power
cord M into a socket. When the control light G switch off, disconnect the iron from the
electric power. Hold the iron in the horizontal position over a sink. Press the SELF cLEaN
button repeatedly (two to three times), each time for about 5 seconds. Then wait till water
stops going out from the ironing plate. If the iron still contains a lot of impurities, repeat the
procedure while pushing the intensive steaming button between individual pushing of the
SELF-CLEAN button.
After completing the cleaning, plug the iron into the electric power, set the selected
program and then iron a clean piece of cotton cloth so that the ironing plate is cleaned.
Storage
After finishing ironing, pour out the unused water from the container ( be careful, it can be
hot), or let the rest of the water evaporate and let the iron cool down. Then turn regulator
D to 0 position (steam switched off). Wind power cord M over the back side of cover L and
put the iron to the rest position (Fig. 8) out of reach of children and incapacitated persons.
IV. MaINTENaNcE
Before every maintenance, unplug the iron from power supply by taking the fork of
the power cord out of the socket! Do not use rough and aggressive detergents (e.g.
sharp objects, peelers, pot scourers, caustic agents for cleaning or other solvents).
Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown film is created
on the ironing plate (e.g. when ironing starched laundry), you can remove the film by
a detergent containing fine sand.
The iron ETA 1283, ETA 2283, ETA 3283 and ETA 6283 is equipped with a permanent
decalcification system aNTI caLc that does not require maintenance. But the system
cannot prevent creation of calcareous sediments.
19
GB
/ 58