ETA Choppic - Manual (Page 14)

14
GB
- Do not put the appliance into bodily holes.
- After putting the cover and driving unit to the vessel the safety device shall release and
the appliance can be switched on.
- Do not switch the appliance without materials put in!
- Let the rotating parties stop completely before taking off the driving unit from the vessel.
- Before emptying the vessel take off the sickle-shaped knife first.
- While handling the sickle-shaped knife be careful as it is very sharp. You have to be very
careful while handling the sickle-shaped knife mainly while taking it off the vessel, at
emptying the vessel and during its cleaning.
- When leaving the appliance without supervision, always detach it from the power supply.
- Do not process foodstuffs having higher temperature than about 80 °C.
- If the processed foodstuffs start to stick on the accessories (e.g. on knife or on
the vessel), switch off the appliance and clean the accessories carefully (e.g. with
a spatula).
- Supply cord must not be damaged by sharp or hot subjects, by open flame and it must
not be immersed in water.
- If you need to use extension cable it must not be damaged and it must comply with the
valid standards.
- Never use the appliance for other scope than for which it was intended and described in
the present instructions!
- The manufacturer does not answer for damages caused by wrong use of the appliance
and its accessories (e.g. devaluation of foodstuffs, injury by knife-edge, fire) and he
does not guarantee for the appliance if the above stated security advices have not been
observed.
II. DESCRIPTION OF THE APPLIANCE AND OF ITS ACCESSORIES (Fig. 1)
A – Driving unit
A1 – Switch
A2 – Safety device
A3 – Supply cord
B – Cover of the vessel
B1 – Securing projection (it activates and deactivate the safety device)
B2 – Seal
C – Glass vessel
C1 – Central shaft
D – Antiskid pad
E – Sickle-shaped knife
F – Whisking extension
III. OPERATING INSTRUCTIONS
Remove all the packing material and take out the appliance with its accessories. Remove
all possible adhesive films, stickers or paper from the appliance. Before the first using the
appliance wash all the parts that will come into contact with foodstuffs in warm water with
detergent, rinse thoroughly with clean water and wipe dry.
Whenever working with the appliance do not forget to put the antiskid pad D under the
glass vessel. The glass vessel C is suitable for use in microwave oven.