ETA Bublimo - Manual (Page 26)

V. TROUBLESHOOTING
Problem Cause Solution
Water is
insufficiently
carbonated with
CO
2
Insufficient pressing of the
button A1
Press the button A1 more than once
Insufficient amount of water
in the bottle
Fill the bottle up with water up to the
MAX level
The water for carbonation is
warm
Use cold water
The carbonator is empty Replace the carbonator with a new one
The carbonator is very cold Wait until the carbonator reaches
ambient temperature
The carbonator is not
installed properly
Apply reasonable force to tighten the
carbonator
Disturbing noise
during water
carbonation
The carbonator is not
installed properly
Apply reasonable force to tighten the
carbonator
Worn-out or damaged
sealing
Check or replace sealing with
a corresponding new one
PET bottle is not properly
installed
Tighten the PET bottle end to end
Gas leaks after
the button
A1 has been
released
The carbonator valve is
damaged
Do not remove the bottle or the
carbonator. Let the gas leak and then
remove the carbonator (ATTENTION:
it may be very cold) and return it to the
supplier
Water foams
and leaks from
the bottle during
carbonation
Syrup has been added in
the bottle with water, ice or
crushed ice
Only use pure drinking water for
carbonation
There is water
under the soda
maker
The amount of water in the
bottle exceeds the MAX level
Only fill up the bottle with water up to
the MAX level
The button A1 was pressed
for too long, too fast or
several times
Press the button shortly, wait for 5 – 10
seconds between presses and do not
press more than 3 times
Button A1 has been
released too fast
The button must always be released
slowly
VI. MAINTENANCE (Fig. 16)
Do not use abrasive and aggressive cleaning agents (e.g. sharpobjects,alcohol,
chemicalsolvents,diluents,ammoniac,causticagentsetc.). Wipe off the interior and
exterior and with a damp cloth after each use.
26
GB
/ 45