ETA Svářečka fólií Electronic - Manual (Page 15)

– The product is intended for home use and similar (in shops, offices and similar workplaces,
in hotels, motels and other residential environments, in facilities providing accommodation
with breakfast). It is not intended for commercial use!
– Make sure the power supply meets the voltage marked on the label before power on
the appliance.The power cord plug has to be connected to the properly connected and
grounded socket according.
– Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or
wet, unplug it immediately, let the appliance dry thoroughly a have it checked by
a professional before next use. Do not put it in water.
– Do not plug or unplug the power cord fork with wet hands or by pulling at the cord.
– Do not leave the appliance running without attendandce and check it during the whole
process of welding!
– Do not leave appliance when plugged in. Unplug from outlet when not in use.
– Never immerse the welder in water and do not wash in running water!
– When handling the appliance, be careful not to induce injuries (e.g. burning).
– It is not acceptable to adjust the surface of the appliance in any way (e.g. sticker
wallpaper, foil, etc.)!
– Use the welder only in its working position in places where there is no danger of toppling
over and in sufficient distance from flammable objects (e.g. curtains, wood etc.), heat
sources (e.g. stoves, cookers etc.) and damp surfaces (e.g. sinks, basins etc.).
– If the electric welder was stored in lower temperatures, leave it in room temperature whih
will help keep the mechanical firmness of the parts.
– The welder is equipped with a safety feature against over-heating. If the appliance should
over-heat, turn it off, unplug and let cool down.
– Do not use the appliance with a programmer, time switch or any other device that turns the
appliance on automatically because there is a danger of fire, if the appliance is covered or
improperly placed.
– WARNING: Appliance not far continuous use. Approved for one operating cycle per 2 minutes.
– Do not vacuum seal liquids.
– The air openings must not be covered. Do not push or throw any objects into the openings.
– Do not try to repair the appliance on your own. Always contact an authorized technician.
– Do not do the following: pull or carry by the cord, use cord as a handle, or pull cord around
sharp edges or corners. Do not operate appliance over cord. Keep cord away from heated
surface.
– It’s better not to use an extension cord with this unit. However, if one is used, it must have
a rating equal to or exceeding the fating of this appliance.
– Check the appliance and the cable for damage on a regular basis. Do not use the
appliance if it is damaged.
– Use this appliance only for its intended purpose described in these instructions for use!
Never use the appliance for any other purpose!
– After completion of the vacuum process leave the cover of the appliance open for the welding
part to cool down.
– The manufacturer is not responsible for damages caused by misuse of the appliance
(e.g. degraded food, injury, burning, fire) and is not liable under the warranty for the
appliance in case of violating the above-mentioned safety cautions.
15
GB
/ 28