ETA Mlýnek na kávu - Manual (Page 13)

13
GB
/ 26
– Never put your fingers or any other object between the rotating parts of the grinder.
– Never submerge any part of the grinder in water.
– The grinder must never be used near a source of heat.
– Do not insert or take the plug out of a socket with wet hands and do not pull the power
cord!
– It is not permissible to adjust the surface of the extra attachment (e.g. self-adhesive
paper, foils, etc.)!
– Do not use the appliance in connection with a programmer, a timer or any other
appliance that switches the appliance on automatically.
– Always use the grinder only in places where there is no danger that it could overturn.
– Be careful to use only good quality coffee beans and check whether they are free of any
articles which could damage the grinder.
– Before plugging the kettle in the mains, make sure there is some coffee in it.
– The grinder filler capacity is 100 grams of coffee.
– In case there is more than 100 grams of coffee to be ground, leave the grinder on
standby for at least 15 minutes between each batch to allow the motor to cool down.
– The coffee grinder is fitted with an automatic thermal cutout protecting the grinder
motor from overheating. Should the cutout have tripped, switch the coffee grinder
OFF and leave it to cool down for about 20 minutes. After that time, you can
continue using the coffee grinder as described in the operating manual.
– It is a good idea to check the grinder from time to time when it is in operation.
– Never remove the lid or filler while there is some coffee being ground.
– After use, unplug the grinder from the mains.
– To avoid danger in case of damage to the flex, a damaged flex must be repaired or
replaced by the manufacturer, its service engineer or a similarly trained person.
– Do not wind the power cord around the appliance; this will extend life of the power cord.
– The power cord must not be damaged with sharp or hot objects, open fire; it must not
be sunk into water or bent over sharp edges. Never put it on hot surfaces or do not let it
hang over the edge of a table or work tables. Hitting, stumbling over or pulling the power
cord e.g. by children can result in tilting over or drawing the appliance down and serious
injury!
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Never use the appliance for any other purpose than that described in these instructions
for use!
– The producer does not undertake any responsibility for damage caused by improper use
of the appliance (e.g. food deterioration, injury caused, fire, etc.) and its guarantee
does not cover the appliance in the case of failure to comply with the safety warnings
above
II. PRODUCT DESCRIPTION (Figure 1)
1) Grinder lid 5) Bottom lid
2) Grinder body 6) ON/OFF switch
3) Lower cover 7) Grinder foot
4) Container