ETA Liliana Klešťová kulma - Manual (Page 15)

Hair styling
Use the hot comb on dry or slightly moist hair, never on wet hair. Comb the hair before
using the comb so that they are not tousled. The ending A4 stays cold during operation
and allows hair styling with both hands. Fix a lock of hair A5 to the heated-up tube A3.
Move the hot comb to the end of the hair and then wind the lock in a desired direction with
several turns. Do not wind locks too thick on the tube when hair styling. Let the heat affect
the hair for several seconds then unwind the lock and release. Repeat the process until the
desired hairstyle is achieved. Let the hair cool down before final styling.
Notes
– This device was designed to make rings and curls of various sizes.
– Freshly washed and dried hair is easier to dress.
– First, learn to use the device on a small part of the hairstyle.
– The result depends more on the strength and length of hair than on the length of
goffering. In the beginning, you may start with goffering of 10 – 20 sec. If necessary,
repeat the process till achieving the desired effect.
– In order to get curls and rings of various sizes, comb the hair and separate (a lock of
hair of about 2 cm wide). Curl only one lock of hair on the iron. Begin from the roots all
the way to the ends. (pic. from 2 to 4).
– The bigger strength you use to wind the lock of hair on the iron and the longer you hold
it pressed, the firmer waves you achieve. After time needed to create a curl, loosen the
lock from the iron carefully (pic. 5). In order for the curls to last, wind them around your
finger and wait for them to cool off.
– Let the hair cool off before combing or brushing them.
i
IV. MAINTENANCe
Turn off the appliance before any maintenance, disconnect it from power supply
by unplugging the power cord from the electric socket and let it cool down! Do not
use rough and aggressive detergents! Treat the surface with a wet and soft cloth. Put the
cooled straightener to a safe and dry place, out of reach of children and incapacitated
persons.
V. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electrical or
electronic products must not be disposed of together with municipal waste. For proper
disposal, hand them over at special collection places where they will be accepted free of
charge. Suitable disposal of the product can help to maintain valuable natural resources
and to prevent possible negative impacts on the environment and human health, which
could be the possible consequences of improper waste disposal. Ask for more details at
the local authority or at the local waste collection site. Fines can be imposed for improper
disposal of this type of waste in agreement with the national regulations. If the appliance is
to be put out of operation for good, after disconnecting it from power supply we recommend
cutting off the power cord and thus it will not be possible to use the appliance again.
15
GB
/ 26