ETA Liliana - Manual (Page 15)

–
If the power cord of the appliance is corrupted, it has to be
replaced by the producer, its service technician or a similarly
qualified person so as to prevent dangerous situations.
– The appliance is intended for use in households only and for similar use! It is not
designed for use in hair salons or for similar commercial use!
– Do not use the appliance close to water contained e. g. in containers, sinks, bath
tubs, swimming pools, etc.
– Do not plug or unplug the appliance from a socket with wet hands and do not pull
the power cord!
– Do not let the appliance in operation without supervision!
– Do not put the dryer on hot heat sources (e. g. oven, stove, radiator, etc.)
– Any part of the appliance must not get in contact with places sensitive to heat (e. g. eyes,
ears, neck, etc.).
– If the dryer was stored at lower temperatures, acclimatize it first, by which you remove
stiffness of the lubricating fat in bearings and mechanical resistance of the plastic parts
will be kept.
– Be very careful when handling the adapter during drying (it is hot).
– The power cord must not be damaged with sharp or hot objects, open fire and it must not
be sunk into water or bent over sharp edges.
– Make sure that the power cord does not hang over the edge of the working table where
children could reach it.
– Holes for air ventilation must not be covered. Also, do not put the dryer in the “on”
position on soft surfaces (e. g. bed, towels, sheets, carpet), the duct could get covered.
Penetration of dust, hair, threads, etc. to the duct has to be prevented.
– Do not insert or throw any objects to the holes.
– It is not permissible to adjust the surface of the extra attachment (e.g. self-adhesive
paper, foils, etc.)!
– Do not insert accessories into any body cavities.
– When the appliance is switched on for the first time, short and slight smoke can come
out that does not mean any defect and it is not a reason for claiming a defect of the
appliance.
– When the appliance is overheated, the automatic heat fuse is activated and it
disconnects power supply. If it happens, switch off the appliance and unplug it from the
socket. Remove possible visible obstacles preventing air flow and let the appliance cool
down.
– Disconnect the appliance from power supply right after use by unpluging the power cord
from the socket and let it cool down before storage.
– Do not wind the power cord around the appliance, this will extend life of the power cord.
– If you need to use the extension cord, it has to be incorrupted and it has to comply with
the valid standards.
– Never use the appliance for any other purpose than for the intended purpose described
in these instructions for use!
– The producer does not guarantee any loss caused by improper handling of the appliance
and its accessories (e. g. electrical accident, fire, burn, hair damage) and its
guarantee for the appliance does not apply in the case of non-compliance with the safety
instructions above.
15
GB
/ 30