ETA Bruno - Manual (Page 30)

4) Slowly move the tip in and out while turning it around at the same time in order to
remove unwanted hair. For best results, make sure the side of the tip is firm against
skin. This will reduce the tickling effect that can occur during trimming of nose hair.
5) Turn off Clipper. Wipe attachment clean after each use.
CAUTION
Do Not insert the tip more than 5 mm into your nostril.
!
Trimming Ear Hair
1) Clean outer area of ear and ear canal. Make sure it is free of wax.
2) Nose, ear and eyebrow attachment B3 should be on the Clipper.
3) Switch the Clipper on and move the tip softly around the edge of ear to remove hairs
extending beyond the outer ear.
4) Carefully insert the tip into outer ear canal.
5) Turn off Clipper. Wipe attachment clean after each use.
CAUTION
Do not insert the tip further than 5 mm into the ear as this could causedamage to the
eardrum.
!
Shaving With Micro Shaver Attachment
1) Put on the shaving attachment B4 on the appliance.
2) Use the narrow micro shaver to shave along contoured edges to remove any stubble
while creating a smooth welldefined beard line. Before using the micro shaver, always
check it for wear and damage. If the micro shaver shows signs of wear or damage, do
not use it as injury may occur. Do not use the micro shaver until it has been replaced.
Gently press the micro shaver onto the skin. Do not press too hard.
Trimming facial hair
Choose the appropriate attachment B1 or B2 depending on your desired length of cut.
1) Wet facial hair slightly and brush it before trimming.
2) Mark a facial hair line with the trimmer and cut off the hairs exceeding this line from
the outer perimeter.
3) If you want to achieve an even trim of facial hair, use one of the attachments C or trim
carefully the ends by small pieces over the brush in such a way that the brush moves
through the hair upwards. Repeat the process in the whole facial hair area.
4) After trimming shave the parts around the beard in a usual way.
5) For more precise styling and trimming you may use the narrow mini-attachment B5.
Trimming a mustache
Choose the appropriate attachment B1 or B2 depending on your desired length of cut.
1) Wet mustache slightly and brush it before trimming.
2) Trim carefully over a brush to achieve an even cut of the mustache.
If you prefer using your finger as a guide, proceed accordingly.
3) For more precise styling and trimming you may use the narrow mini-attachment B5.
GB
30 / 53