Exacq S-Series Enterprise Quick Start Guide - Manual

S-Series Enterprise Quick Start S-Series Enterprise Quick Start
www.e x acq.com
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
www.e x acq.com
+1.317.845.5710
+44.1438.310163 USA (Corporate Headquarters)
Europe/Middle East/Asia
©2013 ExacqTechnologies #
500-00043
1
Hardware Overview and Installation
4U S-Series Enterprise System
2U S-Series Enterprise System
NOTE: A power switch, additional USB ports, and a status display are also located on the front panel of the S-Series Enterprise system.
NOTE: S-series servers are configured for NIC bonding using active backup. Connect the data NIC ports (black) to Ethernet switches. The red NIC
should NOT be used to transmit data. For maximum throughput, configure the network switches for IEEE 802.3ad Link Aggregation, and enable
jumbo frames. Contact Exacq technical support for S-series configuration instructions. Failure to properly configure the S-series and network switch
might cause network failure.
Item # Description Notes
1 Power 100-240VAC 50/60Hz (connect 1a and 1b to separate power circuits)
2 10/100/1000 Ethernet Dual on-board NICs: 2a is for management ; 2b is for data. Additional data NICs: 2c and 2d (optional)
3 USB (up to four ports) Keyboard, mouse, USB memory device, or DVD burner (additional yellow USB ports for charging devices)
4 Video out DisplayPort (4a), DVI-I (4b), DVI-D (4c); a maximum of two video outputs should be used simultaneously
1b 2a 4a 3a 4b 4c 3b 2b 2c 2d 1a
1b 2a 4a 3a 4b 4c 3b 2b 2c 2d 1a