Fire Magic Echelon Diamond Master Switch Replacement Instructions - Manual

REV 0 - 1112021032 L-C2-382 1
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
This master switch is for replacement in an Echelon Diamond
Grill. To install, follow the steps below:
1. Ensure the grill is completely cool, the knobs are in the
off position, the gas supply to your grill is turned off, the
master switch is off, and the power supply is disconnected.
2. Pull off the control knobs. Slowly lift away the lighted bezels to clear
the valve stems, and carefully disconnect the wires found on the
back of the bezels (use your fi ngernail).
3. Remove the smoker drawer and drip tray.
4. Unscrew and remove the control panel screws and washers. Lift
the control panel up and outward, allowing it to rest on the internal
chain(s).
5. Locate the master switch on the right side of the exposed control
panel, and disconnect the wire harness (see Fig. 1-1 ).
6. From the inside of the control panel, use pliers or an open ended
wrench to loosen the nut that is securing the master switch in
place. Use your hand to completely remove the nut. See Fig. 1-2.
7. Remove the master switch.
8. Your grill may have a knockout around the now exposed master
switch opening. If so, use your fi ngers or a tool to completely
remove the knockout (see Fig. 1-3). If not, proceed to the
following step.
Fig. 1-2 Remove master switch nut
MASTER SWITCH
Part # 24182-46
Fig. 1-1 Master switch location
Fig. 1-3 Remove knockout ring (if applicable)
Knockout ring
Remove nut
Disconnect