Fire Magic Diamond Single Sideburner 32794-1 Series - Manual (Page 15)

15
ELECTRICAL SAFETY
To protect against electric shock, do not immerse cord or
plugs (if equipped) in water or other liquid.
Unplug from the outlet (if applicable) when not in use and
before cleaning. Allow to cool before putting on or taking
off parts.
Do not operate any outdoor cooking gas appliance with a
damaged cord, plug, or after the appliance malfunctions or
has been damaged in any manner. Contact the manufacturer
for repair.
Do not let the cord hang over the edge of a table or touch
hot surfaces.
Do not use an outdoor cooking gas appliance for purposes
other than intended.
When connecting, fi rst connect plug to the outdoor cooking gas
appliance then plug appliance into the outlet.
Use only a properly wired and inspected 120VAC (15 AMP
minimum) GFCI GROUNDED 3-wire receptacle with this
outdoor cooking gas appliance.
Never remove the grounding plug or use with an adapter
of 2 prongs.
Use only extension cords with a 3 prong grounding plug,
rated for the power of the equipment, and approved for
outdoor use with a W-A marking.
INSTALLATION (cont.)
SLIDE UNIT INTO ENCLOSURE
Slide the unit into place. Do not to pinch, kink, or damage
the gas connector line.
Note: Each side of the unit has a tab just behind the
control panel. These tabs prevent the control
panel from moving inward. If the tabs interfere
with the unit sliding in (see Fig. 15-1), use
pliers to bend them inward so that they clear
the enclosure sides. Leave the tabs slightly
out to ensure they still keep the control panel
from moving inward (see Fig. 15-2).
POSITION THE BURNER CAP
Place the burner cap so it is centered over the burner.
Ensure that it rests securely in place.
Fig. 15-1 Tab may interfere when sliding in unit
Fig. 15-2 Tab slightly bent in for clearance
REV 2 - 1502100745 L-C2-378